Sygonix 1698497, Руководство по эксплуатации

Страница: 52 / 120

52
• Press and hold this button for about three seconds until the outdoor unit emits one beep. In addition, the LED ring
around the bell button (on the front of the outdoor unit) flashes. The outdoor unit is now in log-on mode (for about
one minute).
• Activate the display on the handset by briefly pressing any key. To display the setting menu, briefly press the left
menu button (10).
• Start the function for registering an outdoor unit to the handset, see chapter 9. The symbol for this func-
tion can be seen in the picture on the right.
• Use or arrow key to select outdoor unit #1 or #2.
Two outdoor units can be registered to each handset. You can thus operate two handsets and two outdoor
units (that is, two complete sets), e.g. to equip two of a house's entrance doors with outdoor units.
In such a case, reset both handsets to the default setting and register both outdoor units to both handsets.
• If the memory for outdoor unit #1 or #2 is empty, briefly press the left menu button (10) to start the login process.
Cancel the registration process using the right menu button (13).
If the memory is full, a garbage bin symbol will appear in the lower left corner andthe memory can be cleared with
the left menu button (10). Confirm the following confirmation prompt with the left menu button (10) or cancel the
action with the right menu button (13).
When signing in, make sure that the outdoor unit is in log-on mode (the LED ring around the outdoor unit
bell button flashes). Otherwise, registration of the outdoor unit is not possible. If necessary, start the log-on
mode of the outdoor unit again as described above.
• The handset emits a beep and a bar graph appears in the lower part of the display (search for the signal from the
outdoor unit). The registration process can take up to 20 seconds.
• If the outdoor unit is found and logged in, the outdoor unit will beep and the LED ring around the bell button will stop
flashing, but will stay lit. On the handset, the display changes back to the time display.
• If you press the doorbell button on the outdoor unit now, a visitor should be reported on the handset and the camera
image should appear. The outdoor unit is registered on the handset.
If this does not occur, start the registration process again.
Make sure (as described above) that the outdoor unit is in log-on mode (the LED ring around the outdoor
unit bell flashes). The registration mode ends automatically after approximately one minute (LED ring stops
flashing).
During this period (LED ring flashing), the log-on mode must be called up and started on the handset!
• Close the battery compartment again and then attach the outdoor unit to the wall bracket.