Sygonix 1698497, Руководство по эксплуатации

Страница: 51 / 120

51
10. Register the outdoor unit to the handset
Normally, this process has already been carried out by the manufacturer. If the outdoor unit and the hand-
set do not react to each other, you can carry out the registration process yourself.
The login process is also required if the handset has been reset to the default settings.
Follow the procedure below to log in:
•
Put the handset into operation (insert the rechargeable battery and charge it if necessary).
• Put the outdoor unit into operation, if not you have not already done so. This requires the voltage/power supply
(either via an external power supply or with two baby/C batteries).
• Test the function of the handset. When you press a key, the display should appear (if necessary, switch on the
handset beforehand by holding down the button (14) for approx. three seconds).
• To test the function of the outdoor unit, press the bell button. Normally the handset should register a visitor and the
camera image should appear. If this is the case, the outdoor unit is already registered to the handset. The procedure
described below is not required.
However, if the outdoor unit only emits a short beep when the bell button is pressed, and a double-beep signal
sounds after a few seconds, the outdoor unit has not found a handset. The handset will also not respond to the bell
button of the outdoor unit. In this case, follow these further steps.
• If you have already mounted the outdoor unit firmly to the wall, then you must remove it for the registration process.
If a sabotage alarm is activated (see chapter 11. e), deactivate it by pressing the button (14) on the handset.
• Open the battery compartment of the outdoor unit. First, remove the four screws (A) and then remove the square
battery compartment cover (B) (note the position).
• There is a small button (C) in the battery compartment, see arrow in the right image.