Swiss Timing TRACKER, Руководство пользователя

Страница: 8 / 21

Page 4
Version 2.1
3442.500.02
2.3 TRACKER DIL switch
Each TRACKER must have its own unique address: one must have the address 1, the
other the address 2. To select the TRACKER address, proceed as follows:

Switch off the TRACKER and unplug the power cable.

Open the rear of the TRACKER with the provided key.

Select the TRACKER address with the DIL switch (use a small screwdriver to move
them):

On some specific cabling (long cables), a termination load may be requested to
ensure correct data transmission between the main judge controller and the
TRACKER; in this case, place a jumper on the pins designated in the above picture.

Close the TRACKER.

Connect the power cable and switch on the TRACKER; during boot, the TRACKER
shows a sequence:
1.
2. Internal software version.
3.
4.
or
Address of the tracker (1 or 2)
5. Tracker ready to be detected and controlled by
the main judge controller.