Strap and Hanger
p/n 22410-17201 and
60840-98020
Although a strap and hanger is not
required for with this unit, it is recom-
mended to reduce operator fatigue during
extended periods of operation. Make sure
all hooks and adjusting devices are secure.
Adjust the harness shoulder strap so the
shoulder pad rests comfortably on the off-
side shoulder. See Figure 9.
Debris Shield
p/n 99909-33021
(optional)
A plastic debris shield is available from
your Swisher dealer as a useful option to
your PowerBroom. The shield helps pre-
vent broadcasting debris when large vol-
umes of material are forced over the top of
the drum during operation. See Figure 10.
Recommended
Strap and Hanger
Figure 9
Figure 10
Optional Accessories
Assembly
Debris shield
8
P230, 231
REAL EPS
Press latch
With the pole pruner on a clean, flat surface,
loosen the coupler screw. The spring-loaded
coupler protector should pop up.
Press down on the latch with your finger
or thumb. This releases the coupler lock.
Pull the upper tube assembly out of the
coupler.
1.
2.
3.
Disassembling the tube sections
Tool assembly
Lower tube assembly
Coupler
Latch
Coupler screw
Knob
Locking hole
Latch protector (extended)
Slip off the protective covers from the
ends of both tubes, and loosen the cou-
pler screw knob.
Insert the tool assembly into the cou-
pler, with the tool decal facing up, until
the line of the decal is flush with the
end of the coupler.
Twist the tool assembly back and forth
until you are sure it snaps in place by
the coupler latch.
When the two tube halves are locked
together, press down on the spring-
loaded latch protector and tighten the
coupler screw knob.
2.
3.
4.
5.
Latch Protector (lowered)
Coupler Screw Knob
Coupler
Assembling tube sections
Place powerhead/lower tube assem-
bly on a clean, flat surface so that
both assemblies fit end to end. The
powerhead/lower tube assembly
should be facing positioned with the
locking hole in the tube end facing up.
1.
CAUTION!
Keep the open ends of the tubes
clean and free of debris!
