6
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front”
and “rear” refer to directions as viewed by
the operator during normal operation.
WARNING!
Do not make unauthorized
modifications or alterations to your
pruner or its components.
Using Figure 4 in the “Product Descrip-
tion” section as a guide, familiarize
yourself with the Swisher E4-U3005 Multi-
purpose Pole Pruner Tool and its various
components. Understanding your unit
helps ensure top performance, longer
service life, and safer operation.
Before assembling, make sure you have
all the components required for a com-
plete unit:
Assembly
Prior to assembly
Outer Tube/Mainshaft Assembly
Gearcase and Shaft Protector
(2) Drum Assemblies
(2) Axles
(1) Handle Assembly
Kit containing hardware, owner/opera-
tor's manual, and a 5 mm hex key.
Carefully inspect all components for
damage.
■
■
■
■
■
■
Adjustable Handle Installation
Follow these instructions if you wish
to use the PowerBroom’s adjustable
handle instead of the loop handle on
youlr powerhead assembly.Remove the
powerhead assembly’s loop handle.
Remove both screws from the PowerB-
room’s adjustable handle assembly.
While spreading the handle at the
mounting hole, position the handle on
the outer tube as shown.
Reinstall the two mounting screws in
the handle, but do not tighten them at
this time.
Locate the handle at the best position
for operator comfort (usually about 10
inches ahead of the throttle lever), and
secure it by tightening the adjustment
knob at the handle base. See Figure 4.
1.
2.
3.
4.
Handle
Hex Nut
Washer
Outer Tube
Adjustment Knob
Mounting Screw
Throttle Assembly
Washer
Figure 4
IMPORTANT!
One side of the handle is recessed to
receive the two hex nuts.
