©
2021 SwellPro Technology
Co., Limited 47
interference)
APP
Mobile App Name
SDFly
Live View Quality
720p@30fps
Latency
＜
250 ms (depending on environmental conditions and
mobile devices)
Flying Guide
•
Many regulations require the pilot to fly a drone within line of sight. Take particular
care when flying a drone out of sight.
•
Unless it is an emergency, NEVER Lock or STOP the motors in flight as this will
cause the drone to fall to the ground and crash.
•
When the low battery level warning is activated, plan to return the drone and land
safely before the battery reaches a critical level.
•
The Return Home function can be used to reorient the drone towards the Home
Point. By activating the Return Home function, the drone will rise to the return
altitude (20m) and then turn towards the Home Point before starting its return.
•
If any obstacles are in the flight path of the drone during a Return Home process,
control should be regained by turning off the Return Home function.
•
If you crash your drone, lock the motors to prevent damage to the motors and
propellers.
•
Do not attempt to touch the motors, until the motors have stopped rotating
completely.
•
When landing on water, avoid abrupt landings to avoid damage to the drone.
•
When flying over water, avoid the drone dropping or crash into the water from a high
altitude as this could cause major damage to the drone.
•
Do not expose the drone & battery to direct sunlight for long periods as this can
raise the internal temperature of the drone to well above the operating temperature
range.
•
If the drone does not appear to be responding to the remote controller, as usual,
switch the drone to ATTI flight mode and fly the drone to a safe landing location.
•
The possible causes for the instability or loss of control of the drone could be poor
GPS signal or radio or magnetic interference or poor calibration practices.
•
If the drone appears to be affected by magnetic interference, try the following
remedies.
•
Re-calibrate both the compass and accelerometer on the SplashDrone 4.
•
After completing the calibration, arm the drone motors to fly in GPS mode to verify
whether this phenomenon has been eliminated.
•
If the abnormality remains the same, please re-locate to another place at least 5KM
away and re-calibrate the SplashDrone 4. Following the re-calibration, please test the
drone again.
•
If the problem persists, please contact SwellPro or your local dealer for further
troubleshooting and solutions.
