©
2021 SwellPro Technology
Co., Limited 23
Return to Home (RTH)
Long press the Return Home button
②
, the remote
controller will beep and vibrate twice to indicate that the
drone will initiate the return to home process. The flight
mode indicator on the remote controller status bar will
change to the letter “R” to indicate the drone is on the RTH
process.
Controls
The patented "" flight control allows the pilot to finely tune the Roll and Yaw of
SplashDrone 4. makes professional, steady flight control as easy as turning
the knobs.
To enter mode, simply press the
buttons.
Press the left button to engage YAW.
The left joystick will now only control the
ascend/descend of the drone.
Press the right button to engage
ROLL. The right joystick will now only control the pitch of
the drone.
BOAT Button
In Boat mode, the SplashDrone 4 can effectively be controlled like a boat on the surface
of the water. With a maximum surface speed of 1m/s.
To enter the Boat mode:
1.
Land or place the drone on the water.
2.
For landing on the water, lock the drone and wait for the motors to stop spinning.
3.
Switch the drone to GPS or ATTI mode.
4.
Arm the drone by using the inward gesture.
5.
Press the BOAT button on the remote controller.
6.
The drone now enters the Boat mode.
7.
Press the BOAT button again to exit Boat mode. The drone can then take off
normally.
Gimbal Button
There are two gimbal modes: Follow mode and Lock mode. The default mode is Follow
mode.
Follow mode keeps the gimbal direction with respect to the direction of the drone.