Swagelok TF72, Руководство пользователя

Страница: 17 / 20

Tube Facing Tool User’s Manual 17
NOTICE
Verify the motor is in drill mode if the motor is
equipped with a hammer mode Operating the tool in
hammer mode will cause damage to the tool and the
tube
Turning “On” the TF72 Series
1. Check that the viewing window is closed, close if necessary.
2. Set the desired speed via the speed adjustment dial.
3. Activate the ON/OFF switch.
Note: If the tool vibrates after starting, the cutting speed is
too high. Reduce the speed according to
Adjusting the
Speed
.
Facing the Tube
■
Each division on the feed dial with scale adjustments equals
an advancement of 0.002 in. (0.05 mm).
■
It is recommended not to exceed a chip thickness of 0.002
in. (0.05 mm) while facing the tube. Excessive feed levels will
reduce the speed or stop the machine.
1. Slowly advance the cutting insert until it is in contact with
the tube.
2. Continue advancing the cutting insert until the desired result
is achieved.
Note: To achieve the optimum squareness and finish, the
tool should be allowed to rotate for 2 to 3 revolutions
without further advancement of the cutting insert.
3. Release the ON/OFF switch.
4. Remove the tube by turning the tube clamp
counterclockwise until it stops.