Swagelok TF72, Руководство пользователя

Страница: 15 / 20

Tube Facing Tool User’s Manual 15
Clamping the tube

CAUTION
Support long pieces of tubing with suitable fixtures
Injury from tilting tool and/or tilting tubing could
result

CAUTION
Verify that the tube facing tool is not rotating before
clamping the tube
NOTICE
The cutting tool can be damaged by incorrect set
up Before clamping the tube, verify there is space
between the cutting insert and the tube
1. Open the collets by lifting the tube clamp counterclockwise
until it stops to open the collets.
2. Insert the tube in the collet set of the tube facing tool.
3. Secure the tube by lowering the tube clamp clockwise until
it stops.
Note: Clamp the tube squarely, ensuring that the tube and the
face of the collet set are perpendicular to each other. The
tube end will not have a right angle cut when this is not
true.
Removing the Tube
To remove the tube from the facing tool, lift the tube clamp until
it stops.
Tool Speed Range
Adjusting the Speed
Set the speed by turning the speed dial.
TF72
Level Tube OD,
in. (mm)
D 1.0 (25.4)
C 1.5 (38.1)
C 2.0 (50.8)
B 2.5 (63.5)
B 3.0 (76.2)
A 3.5 (88.9)
A 4.0 (102)
A 4.5 (114)
Fig 15 Speed Dial
Fig 14 Clamping the Tube
Tube clamp