Swagelok TF72, Руководство пользователя

Страница: 16 / 20

16 Tube Facing Tool User’s Manual
Facing the Tube

WARNING
Allow the machine to run until it stops rotating after
cutting tube to avoid injury

WARNING
Do not touch the tool holder or cutting insert while
the tool is in operation

WARNING
Only operate the tool with a clamped tube and a
closed viewing window

WARNING
Eye protection must be worn while operating or
working near the equipment

WARNING
Keep hands, loose clothing, and long hair away from
rotating and moving parts

WARNING
Wear safety gloves to remove chips Remove long
and bent chips with needle-nose pliers or a similar
tool
NOTICE
Excessive feed of the cutting insert into the tube
can damage the cutting tool or cause the tool to
overheat
NOTICE
Verify there is space between the cutting tool
and the tube before clamping the tube to prevent
damage to the cutting tool The cutting tool can be
damaged by a tube not cut at a right angle
NOTICE
If speed is reduced too quickly, the tool may “dig”
into the tube, causing damage to the tube face and
the tool, and may cause the tool to stop Reduce the
feed rate of the cutting insert and the tool speed
gradually