E.
On the Network Tab
i.
Change the IP Address (if needed) to the appropriate IP Address (usually supplied by
your network administrator
a.
Click the box at the end of the IP Address field
b.
Choose “Use the following IP Address”
c.
Set your IP Address, Subnet Mask, and Default Gateway to their new values.
d.
Select OK
ii.
Make Sure all of the Media Port Options are Checked (advanced users can change this at
a later date if needed)
F.
Select Apply.
i.
This will cause the Transmitters to Reboot, and take on their new IP Address. At this
stage, you may lose communication with the device, as it’s IP address has changed.
Continue changing all of the transmitters in a similar fashion until complete.
3.
Starting with the First Receiver
A.
Double-‐click the device name to bring up the Properties for each Receiver in turn, and do the
following:
i.
General Tab
a.
Change the Name of the Device
b.
Decide if you want to force Audio to Follow Video. If this option is not set, you
can independently switch audio and video streams using advanced control
options.
ii.
Serial Port
a.
If using the on-‐board RS-‐232 Port, configure your port settings as needed.
Testing of RS-‐232 Commands is covered later in this document
iii.
Network
a.
Configure the IP Address of the Receiver. Follow the same steps as setting the IP
Address for the Transmitters.
iv.
Select Apply
a.
At this point, you may lose connectivity to the device as it resets its IP Address.
Continue to the rest of the devices before changing your laptop’s IP Address.
4.
If Needed – Change your laptop’s IP Address.
A.
If you changed the IP Address of the Transmitters and Receivers to something other than
default, then you will need to reset your computers IP Address to match.
Содержание ATR-201
Страница 3: ...Application Examples ...
