A.
Set the computer IP Address to “169.254.20.101”
B.
Set the subnet mask to “255.255.0.0”
C.
Select OK.
6.
Exit out of the Network and Sharing Center.
Step 5: Run Conductor Netlite
Navigate to the install location of your conductor NetLite software – by default this is START>All Programs >
Conductor NetLite. Start the Program.
Step 6: Add devices to system
1.
With NetLite Running:
A.
Select “System Admin”
B.
Select “Add” On Right hand side of the window
C.
Select “Auto Discover Devices”
2.
After Discovery is complete (If Auto Detect did not detect anything – Refer to the Advanced Discovery
Methods Appendix at the end of this document.)
A.
Check the box next to each device you wish to Add, or choose Select All
B.
Click on “Add Selected” and then “Close”
You have successfully added your devices to your system!
Step 7: Organization and Setup of Devices
1.
Close the System Admin Window, and open the Matrix View.
2.
Starting with Transmitters in turn do the following:
A.
Double-‐click the device’s name to bring up the Properties
B.
On the Basic Settings Tab:
i.
Change the Name to something friendlier (I.E. Cable Box 1 or Bob’s Computer)
C.
On the Advanced Tab:
i.
Slide the Image Quality and Motion Quality Faders all the way to the right. This will
insure the highest image quality. If you need to lower the bandwidth used by a
transmitter later on, this is where you would accomplish that.
ii.
Change the Stream Number – Valid numbers are 1 through 255. Organize the stream
numbers as you see fit.
D.
On the Copy Protection Tab
i.
Read the Statement and decide to allow or block copy protected content.
Содержание ATR-201
Страница 3: ...Application Examples ...
