Suzuki Liana RH418, Дополнительное руководство по обслуживанию

Страница: 268 / 371

5A-42 Automatic Transmission/Transaxle:
DTC Troubleshooting
Step Action Yes No
1 Was “A/T System Check” performed? Go to Step 2. Go to “A/T System
Check”.
2 Check Output Shaft Speed Sensor Circuit
1) Disconnect TCM connectors with ignition switch OFF.
2) Check for proper connection to output shaft speed
sensor at “G07-4” and “G07-16” terminals.
3) If OK, check resistance of sensor circuit. Resistance
between terminals “G07-4” and “G07-16” of
disconnected harness side TCM connector: 648 – 792
Ω
at 20
°
C (68
°
F) Resistance between terminal “G07-4” /
“G07-16” of disconnected harness side TCM connector
and ground: No continuity
Are check results satisfactory?
Go to Step 4. Go to Step 3.
3 Inspect output shaft speed sensor
1) Inspect output shaft speed sensor referring to “Output
Shaft Speed Sensor Inspection”.
Is result satisfactory?
“BLK” or “WHT” wire
open or short. Replace output shaft
speed sensor.
4 Check visually output shaft speed sensor and sensor
rotor using mirror for the following
• No damage
• No foreign material attached
• Correct installation
Are they in good condition?
Intermittent trouble or
faulty TCM.
Check for intermittent
referring to “Intermittent
and Poor Connection
Inspection in Section 00
in related manual”.
If OK, substitute a
known-good TCM and
recheck. Clean, repair or replace.
I2RH01510023-01