Sutter Instrument MP-285, Основные операции

Страница: 6 / 40

MP-285 SYSTEM ROE BASIC OPERATIONS – REV. 4.04 (20210122)
iv
Avoiding Electrical Shock and Fire-related Injury

Always use the grounded power supply cord set provided to connect the system to a
grounded outlet (3-prong). This is required to protect you from injury in the event that
an electrical hazard occurs.

Do not disassemble the system. Refer servicing to qualified personnel.

To prevent fire or shock hazard do not expose the unit to rain or moisture.
Electromagnetic Interference
To comply with FDA and CE electromagnetic immunity and interference standards; and to
reduce the electromagnetic coupling between this and other equipment in your lab always
use the type and length of interconnect cables provided with the unit for the interconnection
of the ROE, MP-285/M electromechanical device, and host computer via serial RS-232
interface, (see the Technical Specifications appendix for more details).
Operational
Failure to comply with any of the following precautions may damage this device.

This instrument is designed for operation in a laboratory environment (Pollution Degree
I) that is free from mechanical vibrations, electrical noise and transients.

This unit is not designed for operation at altitudes above 2000 meters nor was it tested
for safety above 2000 meters.

DO NOT CONNECT OR DISCONNECT THE CABLES BETWEEN THE
CONTROLLER AND THE MECHANICAL UNITS WHILE POWER IS ON.
Please allow at least 20 seconds after turning the unit off before disconnecting the
mechanical units. Failure to do this may result in damage to the electronics.

Operate this instrument only according to the instructions included in this manual.

Do not operate if there is any obvious damage to any part of the instrument.

Operate only in a location where there is a free flow of fresh air on all sides.
NEVER ALLOW THE FREE FLOW OF AIR TO BE RESTRICTED.

Do not operate this instrument near flammable materials. The use of any hazardous
materials with this instrument is not recommended and if undertaken is done so at the
users’ own risk.

Do not attempt to operate the instrument with the manipulator shipping screws in
place - severe motor damage may result.

Do not operate if there is any obvious damage to any part of the instrument. Do not
attempt to operate the instrument with the manipulator shipping screws in place - severe
motor damage may result. When transporting the mechanical manipulator, be sure to
install the shipping screws supplied in their correct locations. Failure to do this may
result in damage to the motors.