SurfRAID LC16 Series User’s
Manual
17
2.5.2
Installing the disk
1.
Insert HDD into the cartridge.
2.
Connect the flat cable to the disk. Verify pin 1 (also designated by the color strip) of the
cable is aligned with pin 1 of the disk connector.
3.
Connect the power cord to the disk drives power connector.
4.
Fasten the screws to mount the drive in the disk cartridge. Make sure the drive is prop-
erly tightened
2.5.3
Installing the disk cartridge
1.
Make sure the handle is up and the latch is in the unlocked position.
2.
Gently slide the disk cartridge to the end of the slot then firmly push until the face plate
of the disk cartridge is flush with the front panel of the
SurfRAID
LC16.
3.
Push down the handle to secure the disk cartridge into the
SurfRAID
LC16.
NOTE:
If the
SurfRAID
LC16 is powered up, the disk LED will turn from red to green to
indicate that power has been applied to the disk drawer.
4.
Slide latch to the locked position.
Power Connector
Screws
IDE Cable
3
