Surefire iBURNER BMS-100, Руководство по установке и эксплуатации

Страница: 31 / 40

31
NOTE:
If the present issue is not resolved by the above steps, please call
SureFire Technical Support @ 505-333-2876
SHUTDOWN CODES
Status Codes Symptom Action Visual
16
Shutdown Interlock
 Pilot flame not present
 Ports 23 & 24 are activated
 System detecting an open circuit
 Customer supplied switch is activated
 Check switching device for faulty opera-
tion
 Verify wiring from switching device
 Verify jumper is installed
 Jumper is required if function is not be-
ing utilized
 Blinking Red
LED
17
ESD Activated
 Pilot flame not present
 Ports 23 & 24 are activated
 System detecting an open circuit
 Customer supplied switch is activated
 Check switching device for faulty opera-
tion
 Verify wiring from switching device
 Verify jumper is installed
 Jumper is required if function is not be-
ing utilized
 Blinking Red
LED
18
Replace FT-Ignition
Unit
 Pilot flame not present  Igniter Ohms exceeded 4 Ohms
 Check ohms after igniter has cooled
 Igniter has deteriorated causing high
ohms.
 Ensure proper flame sensing mode has
been selected
 Blinking Red
LED
19
T/C Flame Sensor
Error or Disconnected
 Pilot flame not present  Check device for failure
 Verify wiring from device
 System detecting a disconnect upon ini-
tial start-up
 Ensure proper flame sensing mode has
been selected
 Blinking Red
LED
TROUBLESHOOTING GUIDE