Surefire iBURNER BMS-100, Руководство по установке и эксплуатации

Страница: 15 / 40

15
Flame Sensing Switch (Igniter or
Thermocouple)
Flame sensing mechanism will be dependent on the ignition
unit being utilized. Ensure proper flame sensing mode has been
selected. See Fig.1

For Igniter flame sensing, the igniter wires terminate at
ports 27 & 28 and position switch on igniter.

For thermocouple flame sensing terminate the red (-) wire
at port 5 and the yellow (+) wire at port 4 and position
switch on thermocouple.
NOTE: Switch must be placed in proper position before power
is applied to circuit board. Do not switch while circuit
board is powered up.
Fig. 1
Solar Panel / 12 or 24 VDC Power Source
1. Install 12 VDC Solar Panel or a 12V / 24V DC power source
2. Connect negative (-) terminal to port 29
3. Connect positive (+) terminal to port 30
NOTES:

Maximum rating for solar panel is 75 watts

When using 24 VDC, amps are limited, max current is 75 watts
or 3 amps (Current limiting device is recommended)

Circuit board has internal charge controller to charge 12 VDC
battery, if a battery is connected to port 31 & 32

When using a 12VDC power source, output voltage needs to be
set at
14VDC.
Battery
1. Install a 12VDC SLA battery within an enclosure
separate of the SureFire enclosure.
2. Connect negative (-) terminal to port 31
3. Connect positive (+) terminal to port 32
NOTES:

If battery is more than 10 feet away from SureFire
controller, use larger wire as needed. See page 28.

If utilizing 12 VDC power supply, set voltage @ 13.4
VDC. Power supply should be rated for 90 + watts.
INSTALLATION GUIDE