Surefire iBURNER BMS-100, Руководство по установке и эксплуатации

Страница: 30 / 40

30
SHUTDOWN CODES
Status Codes Symptom Action Visual
11
Manual/Remote Shut
Off
 Pilot flame not present  System has been turned OFF Manually
 System has been turned OFF remotely by
a momentary switch signal to the Remote
Off terminals, ports 15&16
 Display reads OFF
 Red LED ON
12
Max Retries Exceeded
 Pilot flame not present  System has exceeded set number of at-
tempts without success.
 Verify proper fuel pressure, air/fuel mix-
er setting and amperage to igniter.
 Verify proper valve operation: Solenoids,
diaphragm valve, actuator valve, etc.
 Plugged orifice on pilot fuel gas
 Blinking Red
LED
13
Low Battery Voltage
 Pilot flame not present  Battery or power supply below minimum
voltage required to operate system
 Verify battery volts is 12.0 volts
 Check or replace battery if required
 Check solar panel for faulty operation
 Blinking Red
LED
14
Igniter Disconnected
 Pilot flame not present  Check wiring installation and installation
specifications
 Igniter element could have wore out or is
broken.
 Check power supply.
 Blinking Amber
and Red LED
15
Igniter Short
 Pilot flame not present  Ensure igniter wires are not touching
each other or grounding to conduit.
 Ensure there is no moisture in the con-
duit.
 Blinking Amber
and Red LED
NOTE:
If the present issue is not resolved by the above steps, please call
SureFire Technical Support @ 505-333-2876
TROUBLESHOOTING GUIDE