27
PROGRAMMING MODE 22
[001] - [008]
System Options
When an Address is entered, the 8 zone lights on the keypad will be used to indicate which System Options have
been enabled.
• When a zone light is OFF, that Option is disabled
• When a zone light is ON, that Option is enabled
To enable an option, press the number key corresponding to the desired zone light. For example, in Address
[001], press 1 to enable Option 1 Open/Close Report; press 2 to enable Option 2 Close Confirmation, and so on.
When in other Addresses, refer to the Programming Worksheets to determine which zone lights represent which
System Options. For example, in Address [002], zone lights 1 through 8 represent Options 9 through 16.
Pressing a number key to select an Option will either turn the desired zone light ON or OFF:
• If the zone light is ON, pressing the key will shut the light OFF
• If the zone light is OFF, pressing the number key will turn the light ON
Address 001: System Options
Light
1
Open/Close Reporting Select
When “on”, openings and closings are reported to the monitoring station when arming and disarming the
panel.
2
Close Confirmation (Ring-Back)
When “on”, the Exit Delay will only begin when a kissoff from the monitoring station is received. The Keypad
will beep when the kissoff signal is received, and the “Ready” light will flash to indicate that the Exit Delay is in
progress. For this option to function, Option 1 Open/Close Report must be turned on.
3
Force Arming Select
When “on”, the system may be armed even when zones are open. However, all armed zones must be
closed at the end of the Exit Delay or alarms will be generated.
4
Reserved
5
Quick-Arm Select
When “on”, the system may be armed without an Access Code by pressing the [7] and [8] keys
simultaneously.
6
Alarm Memory Indication
When “on”, the Keypad will beep when an alarm is in memory. The Keypad will beep until the alarm is
acknowledged by entering one of the Memory Display Modes (Modes 08, 09 or 10).
7
Siren Driver Enabled
When selected, the Bell output will be modulated to drive a speaker or siren.
8
Bell Squawk Enabled
When “on”, the bell/siren will sound one short burst when a Group is armed, and two short bursts when a
Group is disarmed.
Address 002: System Options
Light
1
Access Code Required for Bypassing
When “on”, the Master Code or an Access Code must be entered to bypass zones.
2
Immediate Bypass Report
When “on”, a report is immediately sent to the central station when a zone is bypassed or when zone
bypasses are cleared.
3
Bypass Report on Exit
When “on”, a bypass report is transmitted to the monitoring station when the panel is armed.
4
Common Bypass Report
When “on”, the system will transmit only one code when all zones are bypassed or when all bypasses are
cleared. Note that the report will not be sent if only a few zone bypasses are cleared; all zone bypasses have
to be cleared before the report will be sent to the central station. When this option is turned off, the system
will transmit an individual bypass/clear bypass report for each zone.
firealarmresources.com
firealarmresources.com
