14
PROGRAMMING SECTIONS
8 After an Address is entered, the following operations can be performed:
Change Address Data
The data displayed at the Address may be changed by keying in the new data. After programming the new
data, the Keypad will automatically advance to the next Address. Note that the Keypad will not automatically
advance from “Light ON / Light OFF” Addresses.
Save Changes and Advance to Next Address
Save any programming changes entered and advance to the next Address by pressing the [
∗
] key.
Display Any Address
Move to any Address by pressing [#] Key. The “Memory” light will flash when the [#] Key is pressed; enter the
3-digit number of the desired Address.
NOTE: When the Keypad is waiting for an Address to be entered (the “Memory” light will be flashing), press the
[
∗
] Key to enter a new Installer‘s Mode.
For example, to move from Mode 20 to Mode 21, press the [#] Key to make the “Memory” light flash. With
the “Memory” light flashing, press the [
∗
] Key, then press [2][1] to enter Mode 21. Note that the Installer’s
Code does not need to be entered to move between Installer Modes.
firealarmresources.com
firealarmresources.com
