Supero SuperWorkstation 5037A-IL, Руководство пользователя

Страница: 66 / 121

5-26
S
uper
W
orkstation 5037A-IL User's Manual
ME Manufacturing Mode (JPME2)
Close pins 2-3 of JPME2 to enable ME Manu-
facturing Mode. See the table on the right
for jumper settings. Note: ME Manufactur-
ing Mode may be enabled without changing
this jumper through the BIOS setup. See
PCH-FW Configuration -> Firmware Update
Configuration in the BIOS Setup. The /ME
parameter must be specified when updating
with the DOS utility.
ME Recovery Mode (JPME1)
Close pins 2-3 of JPME1 to enable ME Re-
covery Mode. See the table on the right for
jumper settings.
JPME2
Jumper Settings
Both Jumpers Definition
Pins 1-2 Disabled
Pins 2-3 Enabled
JPME1
Jumper Settings
Both Jumpers Definition
Pins 1-2 Disabled
Pins 2-3 Enabled
Audio Enable/Disable
Jumper Settings
Both Jumpers Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Audio Enable (JPAC1)
JPAC1 allows you to enable or disable
the onboard audio support. The default
position is on pins 1 and 2 to enable on-
board audio connections. See the table
on the right for jumper settings.
Watch Dog Timer Reset (JWD1)
Watch Dog Timer Reset (JWD1) is a sys-
tem monitor that can reboot the system
when a software application hangs. Close
Pins 1-2 to reset the system if an applica-
tion hangs. Close Pins 2-3 to generate a
non-maskable interrupt signal for the ap-
plication that hangs. See the table on the
right for jumper settings. Watch Dog must
also be enabled in the BIOS.
Watch Dog Timer Reset
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled