Supero SuperServer 7043L-8R, Руководство пользователя

Страница: 57 / 114

Chapter 5: Advanced Motherboard Setup
5-23
33 MHz PCI Enable/Disable
If you wish to use 33 MHz PCI
cards, close J29 to force the P1
bus (slots 2 & 3) to run at 33 MHz.
See the table on the right for jumper
settings.
Note : if you force the slots(s) to 33
M H z , y o u m u s t s e t t h e P 1 b u s
speed jumpers (above) to the low-
est speed.
Jumper
Position
Open
Closed
Definition
Normal
33 MHz PCI
33 MHz PCI
Enable/Disable
Jumper Settings
(J29)
PCI-X Slot Bus Speed Settings
Pin Definitions
(P1, P2, S1, S2)
Pin
Se tting
Pin s 1-2
Pin s 2-3
Pin s 3-4
Pin s 4-5
Speed
PCI 33/66 M Hz
PCI-X 66 M Hz
PCI-X 100 M Hz
PCI-X 133 M Hz
Default setting is PCI-X 100 MHz for all
slots.
PCI-X Bus Speed Setting
Jumpers P1, P2, S1 and S2 are
used to change the speeds for the
four PCI-X buses. See the table on
the right for jumper settings.
PCI-X Buses:
S1: Bus for PCI-X slot #1 and SCSI
P1: Bus for PCI-X slots #2 and #3
S2: Bus for PCI-X slots #4 and #5
P2: Bus for PCI-X slot #6 and LAN2
Note : If two cards are used in slots
that share a bus, both slots will run
at 100 MHz (maximum).
PCI 3.3V Standby Enable/
Disable
JP2 is used to enable or disable a
3.3V standby voltage on pin A14
of the PCI-X slots. If you have a
LAN or modem add-on card in-
serted into a PCI-X slot that you
w i s h t o " w a k e " t h e s y s t e m u p
w i t h , y o u s h o u l d e n a b l e t h i s
j u m p e r . O t h e r w i s e , l e a v e t h i s
j u m p e r o n p i n s 1 - 2 ( d i s a b l e d ) .
The normal (default) position is
disabled. See the table on the
right for jumper settings.
Jumper
Position
Pins 1-2
Pins 2-3
Definition
Disabled
Enabled
PCI 3.3V Standby Enable/
Disable Jumper Settings
(JP2)