Supero SUPERSERVER 6017R-TDLF, Руководство пользователя

Страница: 65 / 118

Chapter 5: Advanced Serverboard Setup
5-19
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connector. The default
setting is 1-2 to enable the connection.
See the table on the right for jumper
settings.
VGA Enable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
I
2
C Bus to PCI-Exp. Slots
Use Jumpers JI
2
C1 and JI
2
C2 to connect
the System Management Bus (I
2
C) to
PCI-Express slots in order to improve
PCI slot performance. These two jump-
ers are to be set at the same time. The
default setting is Closed to enable the
connections. See the table on the right
for jumper settings.
I 2 C to PCI-E slots
Jumper Settings
Jumper Setting Defi nition
Closed Enabled (Default)
Open Disabled
BMC Enable
Jumper JPB1 allows you to enable the
embedded WPCM 450 BMC (Baseboard
Management) Controller to provide IPMI
2.0/KVM support on the motherboard.
See the table on the right for jumper
settings.
BMC Enable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 BMC Enable
(Default)
Pins 2-3 Normal
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that will reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an application
hangs. Close Pins 2-3 to generate a non-
maskable interrupt signal for the applica-
tion that hangs. See the table on the right
for jumper settings. Watch Dog must also
be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled