Supero SuperServer 5013C-M, Руководство пользователя

Страница: 63 / 96

Chapter 6: Advanced Chassis Setup
6-5
Figure 6-4. Installing/Removing the IDE Drive
CD-ROM and Floppy Drive Installation
The top cover of the chassis must be opened to gain full access to the CD-ROM
and floppy drive bays. Both the CD-ROM and the floppy drives must have a "slim"
profile to fit into the 5013C-M.
First, release the retention screws that secure the unit to the rack. Grasp the
two handles on either side and pull the unit straight out until it locks (you will hear
a "click"). Remove the two screws that secure the top cover to the chassis
(located just behind the handles). Next, depress the two buttons on the top of
the chassis to release the top cover and at the same time, push the cover away
from you until it stops. You can then lift the top cover from the chassis to gain
full access to the inside of the server. You must power down the system before
installing or removing CD-ROM, floppy or IDE drives. See Figure 6-4.
Drives mount on rails and should "click" into place to be correctly and fully
installed in their bays.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors to
provide for two floppy disk drives. The connector with twisted wires always
connects to drive A, and the connector that does not have twisted wires
always connects to drive B.