Supero SuperServer 5013C-M, Руководство пользователя

Страница: 22 / 96

2-4
S
UPER
S
ERVER 5013C-M User's Manual
2-4 Installing the 5013C-M into a Rack
(Rack hardware optional)
This section provides information on installing the SuperServer 5013C-M into a
rack unit. If the system has already been mounted into a rack, you can skip
ahead to Sections 2-5 and 2-6. There are a variety of rack units on the market,
which may mean the assembly procedure will differ slightly. The following is a
guideline for installing the unit into a rack with the rack rails provided with the
system. You should also refer to the installation instructions that came with the
rack unit you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer
5013C-M. Each of these assemblies consist of two sections: an inner fixed
chassis rail that secures to the unit (A) and an outer fixed rack rail that secures
directly to the rack itself (B). A sliding rail guide sandwiched between the two
should remain attached to the fixed rack rail (see Figure 2-1). The A and B rails
must be detached from each other to install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull the
inner rail completely out. Do this for both the left and right side rack rail
assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
A
B