Supero SuperServer 4048B-TRFT, Руководство пользователя

Страница: 73 / 148

Chapter 5: Advanced Serverboard Setup
5-25
VGA Enable
Jumper JPG1 allows the user to enable the
onboard VGA1/2 ports on the X10QBi-A
I/O module. The default setting is Enabled.
See the table on the right for jumper
settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
BMC Enable
Jumper JPB1 allows you to enable the
BMC controller on the X10QBi-A I/O
module for IPMI/KVM support. The default
setting is Normal. Refer to the table on the
right for jumper settings.
BMC Enable/Disable
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 BMC Enable
Pins 2-3 Normal
TPM Enable
Jumper JPT1 allows the user to enable
TPM (Trusted Platform Module) support to
enhance data security. The default setting
is Enabled. See the table on the right for
jumper settings.
TPM Enable/Disable
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor
that can reset the system when a software
application hangs. Close pins 1-2 to reset
the system if an application hangs. Close
pins 2-3 to generate a non-maskable inter-
rupt signal for the application that hangs.
Refer to the table on the right for jumper
settings. The default setting is Reset.
Watch Dog must also be enabled in the
BIOS.
Watch Dog
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
I
2
C Bus to PCI-Exp. Slots
Use JI
2
C1 and JI
2
C2 to connect the System
Management Bus (I
2
C) to the PCI-E slots
to improve system performance. These two
jumpers are to be set at the same time.
The default setting is Open for normal
operation. Refer to the table on the right
for jumper settings.
I
2
C for PCI-E Slots
Jumper Settings
Jumper Setting De fi nition
Closed Enabled
Open Normal