Supermicro X10QRH+, Руководство пользователя

Страница: 101 / 131

Chapter 4: AMI BIOS
4-33
SATA/
s
SATA RAID Boot Select
Select SATA Controller to use a device supported by the SATA connector for
system boot. Select sSATA Controller to use a device supported by the sSATA
connector for system boot. The options are SATA Controller,
sSATA Controller ,
and Both.
sSATA Port 0~ Port 3
This item displays the information detected on the installed sSATA drives on the
particular sSATA port.
•
Model number of drive and capacity
•
Software Preserve Support
sSATA Port 0~ Port 3
Select Enabled to enable an sSATA port speci fi ed by the user. The options are
Disabled and Enabled.
sSATA Port 0 ~ Port 3 Hot Plug
This feature designates this port for hot plugging. Set this item to Enabled for
hot-plugging support, which will allow the user to replace an sSATA drive without
shutting down the system. The options are
Enabled and Disabled.
sSATA Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and
Disabled .
sSATA Port 0 ~ Port 3 sSATA Device Type
Use this item to specify if the sSATA port speci fi ed by the user should be con-
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
 Server ME (Management Engine) Con fi guration
This feature displays the following system ME con fi guration settings.
•
General ME Con fi guration
•
Operational Firmware Version
•
Recovery Firmware Version
•
ME Firmware Features