Supermicro SuperServer 7088B-TR4FT, Руководство пользователя

Страница: 45 / 119

45
Chapter 3: Maintenance and Component Installation
Removing/Installing Internal Hard Drives
To remove the cover of the storage module, depress the two release buttons and push the
cover toward the rear of the module as shown below.
2.5" HDDs
The 2.5" hard drives are mounted in brackets that are secured to the bottom of the storage
module tray. See Figure 3-17 for the layout and assembly.
1. Remove the bracket(s) holding the drive(s) you wish to replace by unscrewing from the
bottom of the module.
2. Each drive is held in place in the bracket with four screws. Remove these as well as the
SATA power and data cables then take out the hard drive.
3. Install a new hard drive into the bracket, reconnect the power and data cables and
secure the drive with the four screws.
4. Repeat the steps above as necessary.
5. With all brackets and their drives installed in the module, replace the cover and slide the
storage module back into its bay in the chassis.
6. Depress the power button to boot up the system.