Supermicro SUPERSERVER 6014V-T2, Руководство пользователя, Страница: 42 / 120

5-6
S
UPERSERVER 6014V-T2 User’s Manual
5-4 I/O Ports
The I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-4 below for the colors and locations of the various I/O ports.
Figure 5-4. Rear Panel I/O Ports
5-5 Installing Memory
Note: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage. Also note that the memory is inter-
leaved to improve performance (see step 1).
DIMM Installation (See Figure 5-5)
1. Insert the desired number of DIMMs into the memory slots, starting with Bank
1 (DIMM#1A and DIMM#1B). The interleaved memory scheme requires you to
install two modules at a time, beginning with Bank 0, then Bank 1 and so on.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch along
the bottom of the module to prevent inserting the DIMM module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules (see step 1 above).
Memory Support
The X6DVL-EG2 supports up to 8 GB of registered ECC DDR2-400 SDRAM. You
should not mix DIMMs of different sizes and speeds. See Figures 5-5a and 5-5b
for installing and removing memory modules.