SuperServer 5019S-MN4 User's Manual
27
26
Chapter 3: Maintenance and Component Installation
Figure 3-2. Removing the Processor Cover Plate
Figure 3-3. Placing the Processor into the Socket
2. Gently lift the load lever to open the load plate. Remove the plastic cover plate.
Load Lever
Load Plate
Bottom Edge
Top Edge
3.
Use your thumb and your index finger to hold the edges of the processor. Align the CPU
key (the semi-circle cutouts) with the socket keys.
4. Once aligned, carefully place the processor into the socket. Do not drop the processor
on the socket, move or rub the processor against the socket or against any socket pins,
which may damage the components.
5. With the processor inserted into the socket, inspect the four corners of the CPU to make
sure that it is properly installed and flush with the socket.
Figure 3-5. Installing/Removing the Heatsink
Figure 3-4. Inspecting the Processor Installation
CPU properly
installed
Load lever locked into
place
6. Carefully press the processor load lever down until it locks into its retention tab.
Installing a Heatsink
A passive type heatsink is used on the X11SSH-LN4F.
Note:
Do not apply any thermal grease to the heatsink or the CPU die; the required amount
has already been applied.
1. Place the heatsink on top of the CPU so that the four mounting holes are aligned with
those on the heatsink retention mechanism.
2.
Screw in two diagonal screws (i.e. the #1 and the #2 screws) until they are just snug.
Do not fully tighten the screws or you may damage the CPU.
