Supermicro SUPERO SUPERSERVER 1028R-WTR Series, Руководство пользователя

Страница: 87 / 126

Chapter 6: Advanced Chassis Setup
6-7
Caution: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Superm icro
Web site at http://www.supermicro.com/products/nfo/fi les/storage/SAS-CompList.
pdf
6-5 Power Supply
The SC116 chassis comes equipped with two redundant, hot-plug 700/750 Watt
power supplies (part# PWS-706P-1R). These power supplies are auto-switching
capable and automatically sense and operate at a 100v to 240v input voltage.
An amber light will be illuminated on the power supply when the power is off. An
illuminated green light indicates that the power supply is operating.
Power Supply Failure
The SC116 chassis includes a redundant power supply, which allows the server to
continue running when one power supply has been removed. Replacement units
can be ordered directly from Supermicro.
Replacing the Power Supply (Figure 6-5)
1. Check the LEDs on the power supplies to determine which module has failed.
2. Unplug the power cord from the failed module.
3. Push the release tab (on the back of the power supply) as illustrated, then
pull the power supply out using the handle provided.
4. Push the new power supply module into the power bay until you hear a click
(replace with the same model).
5. Reconnect the power cord to the new module.
Note: Refer to the following FTP site for RAID setup guidelines: < ftp://ftp.supermicro.
com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf > and Supermicro’s web site
for additional inmformation < http://www.supermicro.com/support/manuals/ >.