Supermicro SuperBlade Series, Руководство пользователя

Страница: 34 / 66

SuperBlade User’s Manual
4-4
Module Installation
Make sure the cover to the module has been installed before proceeding. Follow the
anti-static precautions described in
Chapter 2 .
Installing the Module:
1. Remove the dummy cover from the bay you want to place the module in.
2. Place the module's release handle in the open position.
3. Slide the module into the module bay until it stops.
4. Push the release handle to the closed position.
5. After the module has been installed and the handle locked, it will turn on and a
POST test will run to verify it is working properly.
Removing the Module:
1. Pull out the release handle to the open position.
2. Pull the module out of the bay.
3. Replace immediately with another module or with a dummy module cover to
maintain airflow integrity.
Configuring the CMM
To access/configure the CMM, you first have to configure the IP settings of the CMM
depending on you network environment. The below procedure for this configuration just
serves as a reference for getting the CMM setup. If your system has Linux OS, please
follow similar instructions to get the CMM setup.
Requirements are:
• Computer system with LAN (RJ45) port
• RJ -45 Ethernet cable
The default IP of the CMM is 192.168.100.100 . Configure the Computer system
(connected through Ethernet-LAN to the CMM) to the same address range (for example
192.168.100.101).
Configuring the CMM in Windows OS:
1. Go to
S
TART
J
C
ONTROL
P
ANEL
J
N
ETWORK
C
ONNECTIONS
2. Right-click on LAN to view properties.