3-5
Chapter 3: Troubleshooting
Question: I installed my microphone correctly but I can't record any sound.
What should I do?
Answer:
Go to <Start>, <Programs>, <Accessories>, <Entertainment> and then
<Volume Control>. Under the Properties tab, scroll down the list of devices in the
menu and check the box beside "Microphone".
Question: How do I connect the ATA100/66 cable to my IDE device(s)?
Answer:
The 80-wire/40-pin high-density ATA100/66 IDE cable that came with
your system has two connectors to support two drives. This special cable must be
used to take advantage of the speed the ATA100/66 technology offers.
Connect
the blue connector to the onboard IDE header and the other connector(s) to
your hard drive(s).
Consult the documentation that came with your disk drive for
details on actual jumper locations and settings.
Question: I have a P4SPA+ motherboard. The IDE CD ROM on the Secondary
IDE disappears after I install the SATA hard drive.
Answer:
To fi x this, set the SATA to "MANUAL" and set SATA0 to "Primary IDE
Master", then both SATA and Secondary IDE can be seen. If you have your IDE
CDROM on the Primary IDE, then you need to set the SATA0 to "Secondary IDE
Master".
Question: After I have installed 4 pieces of 1GB Memory, why does the BIOS
only detect about 3.75 GB of memory during POST?
Answer:
Because the chipset does not support memory remapping, so there is a
memory hole located around the 4GB memory address.
