Supermicro AS-3014TS-i, Руководство пользователя

Страница: 52 / 119

52
A+ Server AS -3014TS-i User's Manual
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the
system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt
signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default
setting is Reset.
Note:
When Watch Dog is enabled, the user needs to write their own application software
to disable it.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable (JPG1)
JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2
to enable VGA. See the table below for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Definition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
LAN Enable/Disable (JPL)
JPL allows you to enable or disable the LAN ports. The default position is on pins 1 and 2
to enable. See the table below for jumper settings.
LAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Definition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
JNVMe0/SATA0~7 Switch (JFCG1)
This jumper is used to switch between SATA and NVMe for the ports indicated. The default
position is on pins 1 and 2 to enable SATA. See the table below for jumper settings.
JNVMe0/SATA0~7 Switch
Jumper Settings (JFCG1)
Jumper Setting Definition
Pins 1-2 SATA (default)
Pins 2-3 NVMe