Supermicro 8052-6, Руководство пользователя

Страница: 18 / 110

2-2
S
UPER
S
ERVER 8052-8/8052-6 Manual
1/2 inch, at which point the panel should hit a stop. Swing the top of
the panel out and completely lift it away from the chassis. When
reinstalling this panel, make sure the raised holes along the bottom of
the chassis fit into the long holes in the bottom lip of the side panel.
2. Check the MEC:
The Memory Expansion Card (MEC) should be already installed and
populated with DIMMs. Make sure the MEC is secure in its slot and
that the retention plate is screwed firmly to the chassis. For details on
populating the MEC, refer to Chapter 5.
3. Install add-on cards:
Install any add-on cards that you want added to the system. See
Chapter 5 for details on installing add-on cards.
4. Check all cable connections and airflow:
Make sure all power and data cables are properly and firmly connected
and not blocking the airflow. See Chapter 5 for details on cable
connections. Position the airflow guides to concentrate airflow to the
processors and their heatsinks.
Checking the Drive Bay Setup
Open the right side panel to make sure the SCA backplanes are properly
installed and all connections have been made.
1. Remove the right chassis side panel:
To access the drive bays, remove the right side panel (when facing
the front of the chassis) by following the same procedures described
on the previous page for removing the left side panel. You will also
have to open the front doors on the right side of the chassis to
access the front of the drive bays. These doors may be secured with
a keylock located just below the system LEDs.
2. Install an IDE or floppy disk drive:
See Chapter 6 if you need to add an IDE and/or floppy disk drive to the
system.
3. Check the SCSI disk drives:
Depending upon your system's configuration, your system may have
some SCSI drives already installed. If you need to install SCSI drives