Supermicro 8052-6, Руководство пользователя

Страница: 17 / 110

Chapter 2: Quick Setup
2-1
Chapter 2
Server Installation
2-1 Overview and Precautions
This chapter provides a quick setup checklist to get your SuperServer 8052-8/
8052-6 up and operating. Following these steps in the order given should enable
you to have the system operating within a minimum amount of time. This quick
setup assumes that your SuperServer 8052-8/8052-6 system has come to you
with processors and memory preinstalled. If your system is not already fully
integrated with a serverboard, processors, system memory etc., please turn to
the Chapter noted in each step for details on installing these components and
configuring the system.
2-2 Setting up the SuperServer 8052-8/8052-6
You should inspect the box the SuperServer 8052-8/8052-6 was shipped in
and note if it was damaged in any way. If the server itself shows damage
you should file a damage claim with the carrier who delivered it.
Decide on a suitable place for setting up and operating the SuperServer
8052-8/8052-6. You will need to place it in a clean, dust-free area that is
well ventilated. Avoid areas where heat, electrical noise and electromag-
netic fields are generated. You will also need it placed near a grounded
power outlet.
Once the 8052-8/8052-6 is placed in the appropriate location, slide the lock-
ing tabs on each caster down to keep it stationary.
Checking the Serverboard Setup
Open the left side panel (when facing the front of the chassis) to make
sure the serverboard is properly installed and all connections have been
made.
1. Remove the left chassis side panel:
First, make sure the keylock for the side panels (located near the top
at the rear of the chassis) is unlocked. Then remove the four screws
that secure the back lip of the side panel to the rear of the chassis.
Grasp the handle at the rear of the panel and pull straight back about