82
SuperStorage Server 6039P-E1CR16H/L User's Manual
Configure sSATA as
Select AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select RAID
to configure an sSATA drive specified by the user as a RAID drive. The options are
AHCI
and RAID.
SATA HDD Unlock
This feature allows the user to remove any password-protected SATA disk drives. The options
are Disable and
Enable
.
Aggressive Link Power Management
When this item is set to Enable, the SATA AHCI controller manages the power usage of the
SATA link. The controller puts the link in a low power mode during extended periods of I/O
inactivity, and returns the link to an active state when I/O activity resumes. The options are
Disable
and Enable.
sSATA RSTe Boot Info
(Only displays if "Configure sSATA as" is set to RAID.) Select Enable to provide full int13h
support for the devices attached to sSATA controller. The options are Disable and
Enable
.
sSATA RAID Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and
Legacy
.
sSATA Port 0 ~ Port 2
This item displays the information detected on the installed sSATA drive on the particular
sSATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Port 0 ~ Port 2 Hot Plug
Set this item to Enable for hot plug support, which allows the user to replace a SATA drive
without shutting down the system. The options are
Disable
and Enable.
Port 0 ~ Port 2 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are
Disable
and Enable.
Port 0 ~ Port 2 sSATA Device Type
Use this item to specify if the SATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are
Hard Disk Drive
and Solid State Drive.
