Superior SP10/C, Инструкции для установщика

Страница: 5 / 20

H07023980 / DT2000532-02
English
INSTALLATION
DT2032734-0
A
B
Fig. 1
7
1
7
1
DT2032736-0
D
C
Fig. 3
4
5
Fig. 5
DT2032741-0
7
6
E
F
Fig. 4
Fig. 2
DT2012193-00
DT2032735-00
DT2032739-01
- Remove the right side panel following the
instructions given in the par. “
REMOVING
THE CLADDING ” in the instruction booklet
“ INSTALLATION, USE AND MAINTENANCE ”
accompanying the product or the cap.
“
INSTALLATION ” in the “ CLADDING ” instruction
booklet.
- Proceed with removing the primary air shutter
[A] to be found in the pipe on the right side of
the stove, having loosened the relative fastening
screw [B]. (Fig. 1)
- Fit the Ø 40 mm union elbow [1] connected to
the flexible pipe [4], to be found in the kit, onto
the primary air inlet pipe, aligning the hole in the
elbow with the hole in the primary air inlet pipe.
Using the self-tapping screw [7] provided in
the kit, fasten the union elbow. (Fig. 2)
- Remove the rear panel [C] from the stove, having
loosened the relative screws.
Remove the knockout [D] as shown in the figure,
taking care not to scratch or dent it. (Fig. 3)
- Refit the rear panel [C].
- Insert the connector Ø 60 mm [6] of the
combustion air kit into the hole just created in the
panel [C].
Align the slots in the connector [6] with the holes
to be found in the rear panel [C] and fasten the
connector using the self-tapping screws [7]
provided in the kit. (Fig. 4)
- Connect up the connector and the union elbow
previously fastened to the stove, locking the hose
with the clip [5] provided in the kit. (Fig. 5)
- Refit the previously removed cladding in the
reverse order to removal.
- Connect the stove to any fresh air intake.
Insert the end of the connector with the
smallest diameter inside the stove [E].
Check that the hose does not come into
contact with moving parts of the stove
during operation.
5