Superior Radiant Premier VS-VH, Инструкция по установке, эксплуатации и обслуживанию

Страница: 45 / 68

Series Premier VS-VH Page 45 LT135 Dec 2019
Figure 40: Connector Installation Details
5. Electrical Connections
General Requirements
If electronic components are to be installed in an area that is subject to water (drips, spray, rain etc.) then sufficient
means shall be provided by the Installer to protect the components from water ingress.
Ensure that all Electricity to the Supply locations involved has been ‘disconnected’ and ‘locked out’ as per local and
national safety requirements before proceeding with any part of the Electrical installation.
General Wiring
All field wiring and connections must be in accordance with the National Electric Code, ANSI/NFPA 70 in the USA,
and the Canadian Electric Code, CSA C22.1 in Canada, and must comply with all local requirements.
All heaters must be connected and electrically grounded in accordance with the National Electric Code, ANSI/NFPA
70 in the USA, and the Canadian Electric Code, CSA C22.1 in Canada, and must comply with all local
requirements.
Thermostats
Preference is to have each Branch as a separate Heating Zone with a separate Thermostat for better control of
heat levels and fuel usage.
Thermostats must be located/mounted within the operating heat envelope of the Radiant Line Branch being
controlled. Thermostats must be protected/shielded from direct ‘line of sight” with the Radiant Tubing and
Reflectors.