Superior Radiant Premier VS-VH, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 68

Series Premier VS-VH Page 5 LT135 Dec 2019
INTRODUCTION
Superior Radiant Products is a company in the infrared heating industry founded on the principles of product
quality and consumer commitment.
Quality commitment is evidenced by superior design, a regard for design detail and an upgrade of materials
wherever justifiable.
Customer commitment is apparent through our ready responses to market demands and a never-ending training
and service support program for and through our distributor network.
The Premier VS-VH Vacuum System is the culmination of decades of infrared expertise and commitment to quality
products. The VS-VH System is easy to install and maintain, offers flexibility of design which is unmatched in the
industry and provides economical and trouble-free operation.
Important
These instructions, the layout drawing, local codes and ordinances, and applicable standards such as apply to
gas piping and electrical wiring comprise the basic information needed to complete the installation and must be
thoroughly understood along with general building codes before proceeding.
Only personnel who have been trained and understand all applicable codes should undertake the installation.
SRP Representatives are Factory Certified in the service and application of this equipment and can be called on
for helpful suggestions about installation.
Operating Principle
The PREMIER VS-VH System operates on the following basic principles:
 ONE Vacuum Setting is required for all Branches in the System and is independent of which Burner Model is
installed.
 Individual Air Plates have been specially engineered to co-ordinate with the ‘Position’ a Burner is placed in on
any Branch of the System.

Individual Burner Models are specific for a desired BTU/hr heat rating.

Systems may be operated in the following mode:
o
Single Rate: Entire system operates at ONE fixed Rate by setting the Vacuum Setting using Manual
Dampers.
o
Modulating Rate: Burner output Rates may be decreased from ideal designed rate by up to 40%.
 The use of Variable Frequency Drive which adjust the Vacuum Settings of all heaters in the
system by adjusting the pump motor speed allowing the System to modulate.

The use of Motorized Dampers which adjust the Vacuum Settings of individual Branches
allows the System to modulate the overall Heat Output during operation to meet the building
demand.