Series
LTA/LTX/LTXR
Page
22 Nov./21/12
Installation
•
Secure every second reflector overlap together with a minimum of 2 - #8 x 3/8" inch long screws
(not supplied), and secure reflector to the reflector bracket at this point by tightening down #8 x
1¼" inch screws supplied with reflector brackets (Figure 19). The remaining reflector overlap
joints and reflector brackets are left loose to accommodate system movement.
Figure 19: Reflector Supports Installation and Reflector Overlap
•
Install End Cap as shown in Figure 4 and Figure 20.
Figure 20: Reflector End Cap Installation
Secure every second reflector
overlap with a minimum of 2
#8 x 3/8" long screws
on each side
Secure reflector to reflector
bracket by tightening
#8 x 1 1/4" long screws every
other over lap on each side.
Insert End Cap into Reflector
and Secure it with #8 x 3/8" Screws
