Superior Radiant LA series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 33

Series-LA/LX/LXR Page 15 6/15/2010
Installation Sequence
Note: In order to obtain smoothly sealed coupling liners, tighten each of the coupling bands
progressively and alternately. Tightening one band completely before the other may result in
an undesirable wrinkle in the liner.
Note: Be sure not to tile reflector sections; that is, reflector sections must be either above both
adjacent reflector sections, or below both adjacent reflector sections.
•
Install reflector support brackets, one at each reflector overlap position, and one in the middle of
each 10' foot reflector length.
Figure 14
•
Secure every second reflector overlap together with a minimum of 2 - #8 x 3/8" inch long screws
(not supplied), and secure reflector to the reflector bracket at this point by tightening down #8 x
1¼" inch screws supplied with reflector brackets. The remaining reflector overlap joints and
reflector brackets are left loose to accommodate system movement.
•
If required for your heater model (refer to Table 1), install the baffle at the end of the heat
exchanger. The small tab on the baffle is folded over the end of the tube and clamped in place by
the vent connector and vent system.
Note: Baffles are always placed at the end of the last heat exchanger tube length, with the
exception of the 100,000 BTU units which gets a 4’ section in the last three 10’ sections.
Note: Baffles are either one or two sections (4’or 6’). 6’ sections are simply twist locked
together. Where stainless and aluminized sections are supplied, always place the stainless
steel section closest to the burner. The easiest installation method is to pull the baffle through
the tube using a long wire.
Figure 15
Installation of Reflector Support Brackets
1. Place Reflector Bracket
underneath the tube.
2. Hook the Spring Clip with
the Reflector Bracket and over
the tube.
3. Push down the Spring Clip
and slide underneath the
Reflector Bracket.
Reflector Bracket
Spring Clip
Reflector Bracket
Tube
Baffle Installation
Bend Tab
over End
of Tube
Vent
Adapter
Install Baffle
as required in
last section
of tube