Superior Radiant LA series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 18 / 33

Series-LA/LX/LXR Page 16 6/15/2010
Installation Sequence
•
If required by the heater layout, install 90° elbows or U-tube where indicated. Refer to Figure 16
for details.
Note: Elbows or U-bends are typically installed without reflectors. To reduce the above
clearance to combustibles distance use mitered reflectors (see figure 15) and refer to
Clearance to Combustibles information.
Figure 16: 90° Elbow and U-Tube Assembly Detail
•
Elbows or U Tubes must be located not less than 20' feet from the burner in LA/LX/LXR-100 and
smaller models.
•
Install End Cap as shown in Figure 17 and the figure below.
Figure 17
Endcap
Elbow Detail
Couplings
Hanger
Location
U-Bend Detail
Couplings
Endcap Endcap
Hanger
Location
Endcap
Hanger
Location
Installation of End Cap
Insert End Cap into Reflector
and Secure it with #8 x 3/8" Screws