Superior Fireplaces VRE3036ZMN, Инструкция по установке и эксплуатации

Страница: 14 / 28

www.SuperiorFireplaces.US.com
127042-01A 14
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot
before using the hand-held re -
mote control unit. See Lighting
Instructions , page 12.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi -
tion. Adjust flame adjustment knob any -
where between HI and LO. Slide the se -
lector switch to the REMOTE position
on Remote Receiver (see Figure 19).
Figure 19 - Settings for Remote Operation
Selector Switch in
REMOTE Position
REMOTE
OFF
ON
Piezo
Ignitor
Control Knob
Flame
Adjustment
Knob
OPERATION
Continued
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on
and off with the hand-held remote control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
INSPECTING BURNERS
Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame height. Alterations may have
occurred during shipping and handling. Call
a qualified service person to readjust the pilot
if necessary.
The height of the thermopile must be 3/8" to
1/2" above the pilot flame as shown in Figure
22. The thermocouple must be at a height of
about 1/8" above the pilot flame. The flame
from the pilot burner must extend beyond both
the thermocouple and thermopile.
If you pilot assembly does not meet these
requirements:
• turn fireplace off (see
To Turn Off Gas to
Appliance , page 12)
• see Troubleshooting , page 17
BURNER FLAME PATTERN
Figure 23 shows correct burner flame pattern.
NOTICE: Do not mistake orange
flames with yellow tipping. Dirt
or other fine particles are burned
by appliance, causing brief
patches of orange flame.
If burner flame pattern is incorrect, as shown
in Figure 24.
• turn appliance off (see
To Turn Off Gas to
Appliance , page 12)
• see Troubleshooting, page 17
Thermocouple
Thermopile
1/8"
Pilot Burner
Piezo
Ignitor
Figure 22 - Pilot Assembly
3/8" to 1/2"
Figure 23 - Correct Burner Flame Pattern
Yellow Flames with
Orange Streaks
Figure 24 - Incorrect Burner Flame
Pattern
Dark Orange
Flames