SuperiorFireplaces.us.com
900719-00B
28
OPERATION
Continued
Figure 45 - Pilot (Natural)
Thermocouple
Igniter Electrode
Pilot Burner
BLOWER
OPERATION
WARNING: This fi replace has
a three-prong, grounded electri-
cal plug. This plug helps protect
you against electrical shock.
Only connect plug to a properly
grounded, three-prong recep-
tacle. Do not cut or remove the
grounding prong from this plug.
Access the blower control knob by pushing in
on the bottom corners of the
fi
replace screen,
grasp the bottom of the screen and pull out
and up to remove the screen. The blower
control knob is located on the left side of the
fi
replace
fl
oor.
The blower is thermostatically controlled. This
means the
fi
replace and blower will not turn
on and off at the same time. The
fi
replace
may run for several minutes before the blower
turns on. After the
fi
replace is shut off, the
blower will continue to operate until the
fi
re-
place temperature cools.
The blower also includes a variable speed
control. Turn the knob clockwise to turn the
blower to the high position. Continuing to turn
the knob will reduce the speed of the blower
until it reaches a preset low speed.
SWITCHING ON
To turn the system on, press the Burner ON/
OFF switch to the ON position
(see fi gure
on Page 27)
. Once the start up process is
complete, the main burner and pilot will be lit.
REGULATING THE FLAME LEVEL.
1. To decrease the
fl
ame level to low, press
the Hi-Low switch to the ON position.
2. To increase to high
fl
ame level, press the
Hi-Low switch to the OFF position.
NOTE: If the appliance is set to the low fl ame
level and turned off, it will light on high fl ame
level and then cycle to low fl ame level on the
next fl ame sequence.
SWITCHING OFF
To switch off the
fi
re, press the Burner ON/OFF
Switch to the OFF position.
WARNING: Do not convert
heater to use different fuel
type. Only use heater with fuel
type specifi ed.
