SuperiorFireplaces.us.com
900464-01C
15
Installation
Continued
Figure 23 - Installing Back Top Log and Final Assembly
Figure 23A - Installing Back Top Log, Top View
Right Split
Crossover
Log (D-022)
Back Top Log (D-062,
D-023 or D-029)
OPERATION
Figure 24 - Installing Small Left Hand And Right Hand
Logs
For MOA/B logs only, follow steps 9 and 10.
9� Install the small Left Top Log D080 as shown in Figure 24 by
mating the rectangular peg and notch�
10� Install the small Right Top Log D081 as shown in Figure 24�
D-080
D-081
Front Top Left
Front Top
Right
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance does not have a pilot, it is equipped with an
ignition device which automatically lights the pilot. Do not light
pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
C. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
LIGHTING
INSTRUCTIONS
1� STOP! Read the safety information first�
2� Do not attempt to light the burner by hand�
3� Turn equipment shutoff valve clockwise
to the OFF position
(see Figure 25)� Do not force�
4� Wait five (5) minutes to clear out any gas� Then smell for gas,
including near the floor� If you smell gas, STOP! Follow “B” in the
safety information� If you don't smell gas, go to the next step�
5� Turn equipment shutoff valve counterclockwise
to the ON
position� Do not force�
6� Push remote control ''ON'' button�
7� Visually locate igniter� Igniter should begin to spark and main
burner should ignite once flame appears at pilot�
• If lighting appliance for the first time each season, it may take
several attempts before supply gas can reach pilot and main
burners�
• If appliance will not stay lit after several attempts, follow instruc-
tions under To Turn Off Gas To Appliance
and call your service
technician or gas supplier�
TO TURN OFF GAS
TO APPLIANCE
1� Push remote control ''OFF'' button�
2� Turn equipment shutoff valve clockwise
to OFF� Do not force�
Solid fuels shall not be burned in this appliance.
