Installation
900636-01, 01/2017
Innovative Hearth Products
DRT4200 Series Direct-Vent Gas Fireplaces
41
Figure 33 - Electronic Pilot
Igniter
Flame Rod
Pilot Hood
14.
Initialize the Remote Control System for the First Time
1.
Install the four (4) AAA batteries.
NOTE:
Check the polarity (+/-) of the batteries and insert them into the battery bay as indicated on the battery
cover.
NOTE:
See Operation Instructions provided with the remote control.
Figure 34 - Remote Control
MODE Zone
SET TEMP Zone
ROOM TEMP Zone
LIGHT Zone
FLAME Zone
TIME/PROG Zone
AUX Zone
FAN Zone
DOWN Button
MODE/SET Button
UP Button
MODE/SET
BACK
Cont.
S M T W T F S
AM
PM
ROOM
SET
P1
A
B
P2
P2
AUX
P2
Pilot
:
OFF
ON
°
°
u
PROGRAM
USB
MODE/SET
BATTERY
COMPARTMENT
BACK
15.
Verify Proper Fireplace Operation
1.
With the gas line installed, inspect the system before closing the front of the unit.
2.
Follow the pilot lighting instructions:
• Electronic Systems
(
Pages 61-64
)
NOTE:
When lighting the fireplace for the first time, it will take a few minutes for the gas line to purge itself of air.
When purged, the pilot and burner will light and operate as indicated. Subsequent lighting of the fireplace will not
require purging. Inspect the pilot flame (carefully remove logs, if necessary).
Electronic Fireplace Inspection
To light the burner, turn ON the wall or remote control switch. Ensure the igniter lights the pilot. The pilot flame
should engulf the flame rod
(
Figure 33, Page 41
)
.