34
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation and Operation Instructions
900300-00, 01/2018
Innovative Hearth Products
DRT35ST and DRT35PF Direct-Vent Gas Fireplaces
WARNING
• DO NOT attempt to install the logs until the appli-
ance installation has been completed, the gas
line connected and tested for leaks and the initial
burner operation has been checked out.
• The size and position of the log set was engineered
to give the appliance a safe, reliable and attrac-
tive flame pattern. Any attempt to use a different
log set in the fireplace will void the warranty and
will result in incomplete combustion, sooting,
and poor flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to the
appliance before you install grate, volcanic stone,
vermiculite, embers and logs.
• This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage to
the appliance and prove hazardous to your safety.
• If logs are not installed according to the log
installation instructions, flame impingement and
improper combustion could occur and result in soot
and/or excessive production of carbon monoxide
(CO), a colorless, odorless, toxic gas.
10.
Place Log (E) as shown in
Figure 60.
11.
Place Log (F) as shown in
Figure 61.
E
(Valve Access Side)
Position The Round End Of Log (E) Against The Notch Of
Log (D) Here. Two Charred Spots Face The Front
D
Position Small End of Log
(E) on The Notch of Log
(C) Here
C
Figure 60
F
(Valve Access Side)
Log (F) Sits in
Front of The Grate
Figure 61
NOTE: It is important to ensure proper log and or media place-
ment per the manual when installing these units. Verify pilot
flame is not obstructed. See Verifying Appliance Operation on
Page 31.
