30
www.Observint.com
SECTION 3: SYSTEM SETUP
i.
Check the
Record Audio
select box.
ii.
Set the
Pre-Record
and
Post-Record
times using the drop down lists. These parameters set the number of
seconds of video before and after an event occurs what will be saved in storage.
iii. Open the
Steam Type
drop down list to select the video stream you want to record. You can select Dual, but
that requires more bandwidth and storage space.
Main Stream
has the highest resolution.
iv. Set the
Video/Picture Expired Time (day)
parameter as needed. This parameter sets the expired time
for a recorded file to be kept in the HDD. When the deadline is reached, the file will be deleted. If you set the
expired time to “0,” the file will not be deleted. The retention time for a file is determined in consideration of
the capacity of the HDD.
v.
Click
OK
to save your settings.
Setting the Recording Schedule graphically
To graphically configure the recording schedule, simply click the recording mode you want to apply, and then drag a rectangle across
the areas of the array you want to change. Each segment of the array represents 30 minutes. To graphically change the recording
schedule for Alarm recording (type of event created when the AVSI switch is ON):
1.
Open the
Camera No .
drop down list and then select the video in channel the camera in interview room is connected to
(
[A1] Interview Room 1
).
2.
Ensure the Enable Schedule select box is checked.
3.
Click on the
Alarm
recording mode buttons above the array to select the mode you want to use. Mode buttons include:
Continuous
: scheduled recording.
Event
: recording triggered by all event triggered alarm.
Motion
: recording triggered by motion detection.
Alarm
: recording triggered by alarm.
M/A:
recording triggered by either motion detection or alarm.
M&A
: recording triggered by motion detection and alarm.
None
(no mode)
