SUNWARD SWL 2021 Series, Руководство оператора

Страница: 74 / 91

SWL2820 Operator’s Manual
73
Driving Torque for Piston Pump Elastic
Coupler
Driving Torque for Gear Pump Piston
Pump
130 Nm 130 Nm
5.5.5.3 CHECKING THE FLUID LEVEL OF THE BATTERY
For checking the fluid level of the battery proceed as follow:
1) Open the plug on the topside of the battery.
2) Check the acid level. The acid level has to be 6 mm above the plate edge.
3) Refill with distilled water if necessary.
3) Put back and tighten the plug.

Follow all the security regulation describes in the section 2.5.6.

Park the machine on an level surface before checking the fluid level.

In case you get in contact with the electrolyte, wash with plenty water and consult a
doctor.

Grease the terminals with special anti-oxidation if they are oxidized.
5.5.5.4 CHANGING THE HYDRAULIC OIL FILTER

Never change the hydraulic oil filter when the oil is warm.

Used filters must be collected following the local regulation.
Proceed as follow for changing the hydraulic oil filter:
1) Remove the oil tank cap for releasing the remaining pressure inside the tank.
2) Remove the oil filter.
3) Renew the gasket when putting the new filter.
4) Put back the oil tank cap.
5.5.6 EVERY 1000 HOURS OF OPERATION
5.5.6.1 CHANGING THE OIL IN THE GEAR CHAIN BOX
Proceed as follow for draining the oil from the gear chain
box:
1) During the oil is hot (just after use
the machine) screw off the drain
plug located in the front part of the
chassis (see picture below).
2) While the oil’s draining screw off
the screw located on the top of the
chassis (see picture below).
3) Once the oil is drained screw on the plug located in the front part and fill
through the plug located in the top until the oil reaches the lower edge of
the hole. Only fill with oil recommended in the manual.
4) Tighten the screw located in the side.
5.5.6.2 CHANGING THE HYDARULIC OIL AND CLEAN THE SUCTION